FDS WINP User Manual page 5

WINP – Wireless Input
To configure your desired Group, press the Setup button
The current Group selected is indicated by the LED array (A, B, C & D)
Release and press the number of times you want to change the setting.
Group
A
B
C
D
E
F
G (*)
H (*)
OFF
(*) only available for North America and Japan
4.3. TBox-Radio Input (WINP Pairing)
Each WINP/WIRC has a unique ID (serial number) that can be paired with a TBox-Radio input
(A-D).
Pairing can be performed on a TBox using the "TBox-Setup" application (no need to power
ON WIRC/WINP). Pairing can also be performed manually without any application. In this
case, both TBox-Radio and WINP/WIRC have to be powered and the following procedure
executed.
1) On the TBox-Radio, enter the pairing mode by pressing the Setup button
until a long beep sounds and LED A flash yellow.
2) Select then the desired input (A, B, C or D) by performing short press on the same
button.
3) Finally enter the pairing mode on the WINP/WIRC by pressing the Setup button
3 second.
When pairing is completed, LEDs A to D of the TBox flash yellow and both TBox and
WINP/WIRC resume normal operation.
To exit manually the pairing mode on either TBox or WINP/WIRC, just press the Setup button
for 3 second until a long beep sound.
NOTE: In case an IOS or PC application is used to configure the radio inputs on a TBox, do
not use the same WIRC/WINP serial number for more than one input.
December 2021 - Version EN 1.3
www.fdstiming.com
LED A LED B
GREEN
GREEN GREEN
GREEN GREEN
GREEN GREEN
YELLOW
YELLOW YELLOW
YELLOW YELLOW
YELLOW YELLOW
RED RED
User manual
LED C LED D
GREEN
GREEN GREEN
YELLOW
YELLOW YELLOW
RED RED
for 3 sec
for