Next Level Racing ELITE Series Instruction Manual page 7

support@nextlevelracing.com support@nextlevelracing.com
OPTIONAL BUTTON BOX SETUP "A"
(SMART PHONE COMPATIBLE)
)
A
)
B
( )
Tabs
( )
Rear View
13a
Flip the Button Box Top Clamp upside down (the tab should be facing down as shown in the picture)
and align the slots with the pressed studs on the Button Box Bottom Clamp.
OPTIONAL BUTTON BOX SETUP "B"
) )
A B
A) Align the slots on the Button Box Top Clamp with the pressed studs on the Button Box
13b
Bottom Clamp.
B) Secure using M8 Wing Nuts.
PARTS:
• • 1x Button Box Top Clamp
• • 1x Button Box Bottom Clamp
• • 2x M8 Wing Nuts
PARTS:
• • 1x Button Box Top Clamp
• • 1x Button Box Bottom Clamp
• • 2x M8 Wing Nuts
12
) )
A B
14
A) Align the holes on the pre-assembled Tablet Holder with the pressed studs on the pre-assembled
Button Box Holder. B) Secure using M8 Wing Nuts.
) )
A B
NOTE: Replace the Wing Nut with a
Flange Nut for a fixed setup.
A) Align the holes on the Tablet Mount Connector Bracket with the holes on the back of the Tablet Holder.
15
B) Align a 43mm Barrel Spacer in between the Tablet Mount Connector Bracket. Bolt through and secure using
M8 Bolt, Washer and Wing Nut.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2x M8 Wing Nuts
PARTS:
• • 1x M8 60mm Bolt
• • 1x M8 Washer
• • 1x M8 Wing Nut
• • 1x 43mm Barrel Spacer
13