Safety Instructions; Using Your Air Purifier - Hunter HEPAtech 30180 Owner's Manual

SAFETY INSTRUCTIONS

Save These Important Instructions
1. This Air Purifier is designed for use on a flat,
level surface and may not work properly on
an uneven surface. ALWAYS place this Air
Purifier on a firm, level surface. ALWAYS
place the Air Purifier at least six (6) inches
away from walls and three (3) feet from heat
sources such as stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of
the reach of children.
3. Before using the Air Purifier, extend the cord
and inspect for any signs of damage. DO
NOT use the product if the cord has been
damaged.
4. To reduce the risk of electric shock, this
product has a polarized plug (one blade is
wider than the other) as a safety feature.
This plug will fit into a polarized outlet only
one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. DO NOT
attempt to defeat or override this safety
feature.
5. ALWAYS UNPLUG the Air Purifier when it
is not in operation, while the filter is being
changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it
is in operation. Shut off and unplug before
moving.
7. DO NOT immerse the Air Purifier in water
as permanent damage will occur. Refer to
and follow the CLEANING AND FILTER
REPLACEMENT instructions.
8. DO NOT run the ionizer if tobacco smoke, air
fresheners, dripless wax candles, or grease
from cooking is present.
INTROdUCTION
Thank you for purchasing the HEPAtech™ Air
Purification System from Hunter Fan Company.
You have purchased our latest development in
portable Air Purification Systems. This system
has been developed to improve the quality of
the air you breathe.
Our HEPAtech™ Air Purification System out
performs other air purification systems by
©2010 Hunter Fan Company
quickly and effectively removing dust, smoke,
and pollen particles as small as .3 microns in
size. Room air is pulled in through the front grill
where larger particles and odors are caught on
the pre-filter. Smaller particles passing through
the pre-filter are caught on the main filter. The
ionizer helps remove the remaining particles
before being pushed back into the room through
the top vent.

USINg YOUR AIR PURIFIER

1. Take the air purifier out of the box and remove
the clear plastic protective bag. Place the unit
on a firm level floor.
2. Before turning on the air purifier, you need
to confirm that the filters are firmly in place
and have not become loose during shipping.
To check the filters, open the front grill by
placing your fingers under the handle and
pulling the front grill towards you. The front
grill will rest at about 45º. You may then
remove the front grill by placing your fingers
under the handle and pulling the front grill up.
3. The carbon pre-filter is mounted inside the
front grill with hook tape. Confirm that it
properly covers the grill vents. You may
notice a few black particles coming off the
pre-filter. Those particles are part of the
odor-removing activated carbon and will
be collected on the filter during use. The
HEPAtech filter should rest loosely inside the
unit with the arrow on the side of the filter
showing air flow and the direction the filter
should be installed.
4. Place the front grill back onto the unit. First,
line up the tabs on the bottom of the grill
with the openings on the purifier base and
then push the top of the grill forward until it
is closed. NOTE: This unit will not operate
unless the grill is in the correct position.
5. Plug the unit into a 120V electrical outlet.
2
43063-01 20100615