Cartridge Calibration; Prepare The Printer - Ioline FlexJet E User Manual

44 Ioline FlexJet E User Guide
i
Note
Cartridge alignment is not neces-
sary for models with a single
activated cartridge stall.

Cartridge Calibration

i
There are three types of adjustments associated with the ink cartridges.
Most line quality issues are resolved by adjusting these values.
Cartridge Alignment is not necessary on the FlexJet E and Stu-
n
dioJet printers.
Motion Adjustment aligns scans in the direction of carriage travel.
n
Frame Gap aligns scans in the direction of paper movement.
n
Figure 31. Cartridge calibration window.

Prepare the Printer

1. Load the printer with paper. (Follow the loading instructions
under the Operation chapter.) Install cartridges.
2. Move the carriage using the Arrow keys so that the carriage
notch is over the paper and roughly one inch from the right
paper edge.
3. Put the printer in START (green light) mode by pressing the
Set Origin key. (See the Operation chapter for more details on
preparing to plot.)
4. Start the Control Center software. Ensure that there are no er-
rors when the program tries to communicate with the printer.
If errors occur, check the cables and ensure that the correct port
number and baud rate are selected. (See Connect the printer to
the Computer: Overview in the Installation chapter for informa-
tion on serial port connections.)