Advertisement
A
F
x6
B
x6
C
x6
D
x2
1) Glue three 10x40mm Wood Dowels (C) into the upper holes in the Left Leg Assembly (1) and
one 8x30mm Wood Dowel (D) in each end of Seat Brace (6) as shown in FIGURE 1. Attach
the Back (3), with the dowel hole in lower rail to the front, to the leg assembly with two dowels
and two Barrel Bolts (A) and Barrel Nuts (B). Tighten bolts with the Hex Wrench (F).
Attach the Seat Brace (6), with the curved edge up, to the Back with the dowel and Screw (E).
Attach the Front Apron (4) to the left leg assembly and Seat Brace (6) over the dowels and
fasten in place with Barrel Bolt (A) and Barrel Nut (B) and Screws (E).
Glue three 10x40mm Wood Dowels (C) into the upper holes in the Right Leg Assembly (2) as
URE 1. Attach the leg assembly to the front apron and back as before.
shown in FIG
E
x11
FIG. 2
2) Slip the Seat (5) down between the legs onto the seat brace. Attach to the leg assemblies
with Screws (E) through the two predrilled holes in each end of seat into the frame as shown
in FIGURE 2.
Insert a Screw (E) through each of the holes in the bottom of the center Seat Brace (6)
into the slats.
85992KFRS1 Chelsea Bench
ASSEMBLY INSTRUCTIONS
x1
85992KFRS1 – Page 3
Advertisement
