Advertisement
4. Install three, 1.5V AA batteries (not included) into the
battery compartment. Make sure the polarity of the
batteries is correct. Replace the battery compartment
cover.
5. Slide the power switch to the ON position to activate
the motion sensor. When motion is detected, the light
will turn on. The light will stay on for a period of ten
seconds after all motion has stopped to prolong bat-
tery life.
6. Place the top rear of the light fixture over the wall
mounting plate and slide the fixture down onto the
wall mounting plate. Slide the light fixture down until
the bottom tab clicks and locks the light fixture into
place.
Adjusting Spotlight Lamp:
To adjust the vertical position of the lamp, use a Phillips
head screwdriver to loosen the screw on the rear of the
lamp head and rotate the lamp up or down. Tighten the
screw once the adjustment is complete. To adjust the
Power
horizontal position of the lamp, rotate left or right to the
Switch
desired position.
3
FINAL ADJUSTMENT
Advertisement
