Advertisement

Quick Links

®
Operating & Installation Instructions
AUSTRALIA

Advertisement

Table of Contents
loading

Summary of Contents for Charnwood arc7

  • Page 1 ® Operating & Installation Instructions AUSTRALIA...
  • Page 3: Table Of Contents

    INSULATED ROOM SEAL FLUE KIT INSULATED ROOM SEAL FLUE KIT COMPLIANCE DATA ARC 7 DIMENSIONS ARC 7 STORE STAND PARTS LIST ARC 7 LOW STAND PARTS LIST ARC 7 OPTIONAL DRAWER PARTS LIST CHARNWOOD AUSTRALIA 10 YEAR GUARANTEE 28 Ref.ARC7 aus v1 01.21...
  • Page 4: Quick Guide

    Have flue swept anually. Flue can be swept through stove. SERVICING Stove should be serviced by a professional at least once a year. LIGHTING AND CONTROLLING THE FIRE Suitable fuels for your Charnwood: Wood logs Unsuitable fuels: Petroleum coke Liquid fuel...
  • Page 5: Operating Instructions

    Charnwood. Log moisture content of less than 20% is recommended. The Charnwood Arc 7 is fitted with an air control stop. This stops the PETROLEUM COKE IS NOT SUITABLE FOR USE ON THIS stove from burning too slowly.
  • Page 6: Wood Ash Removal Grate

    WOOD ASH REMOVAL GRATE When burning wood, ash should be allowed to build up and only Your Charnwood Arc fitted with a wood ash removal grate to riddled when the ash begins to cover the rear fireplate. The fire enable wood to be burned and ash to be cleared. The grate has two should be riddled with the door shut (see Fig.2).
  • Page 7: Ash Clearance

    If it becomes necessary to clean the Charnwood. glass then open the door and allow it to cool. Clean the glass using a damp cloth and then wiping over with a dry cloth.
  • Page 8: Baffle And Flue Cleaning

    Manufacturer or their approved agents. Your Charnwood flue should be swept at least twice a year. Where Use only genuine Charnwood replacement parts. the top outlet or vertical rear flue connector is used it will generally BAFFLE AND FLUE CLEANING be possible to sweep the flue through the appliance.
  • Page 9: If You Need Further Help

    Your Local and the blanking plate are well sealed. It is also important that the flue Charnwood Dealer has a great deal of experience and will also be draw is sufficient and that it is not affected by down-draught. When able to provide helpful advice.
  • Page 10: Installation Instructions

    If installed on a combustible floor, floor protection must be provided in the form of External air supply kits are available please contact Charnwood for a non-combustible material to the minimum specifications described more information. Instruction sheet ref: TIS 120...
  • Page 11: Connections To Flues

    INSTALLATION INSTRUCTIONS ® in the ‘minimum distances to combustibles’ section (pages 12 - 14) When the fire door is open, it extends beyond the flat front of the COMMISSIONING stove by 450mm. Ensure that the rear heatshield extension is fitted to the back of the If in doubt as to the positioning of the stove, expert advice should be heaishield (part 010/BPA170) with 2 x 12mm self tapping screws.
  • Page 12: Clearances

    CLEARANCES ® PARALLEL POSITION CORNER POSITION COMBUSTIBLE WALLS ARC 7 STORE STAND/ LOW Standard Clearance Corner Clearance 200mm 275mm 369mm 533mm 400mm 648mm...
  • Page 13: Standard Hearth Dimensions

    STANDARD HEARTH DIMENSIONS ® DEFAULT HEARTH TO WALL VERTICAL REAR FLUE ADAPTOR ARC 7 STORE STAND/ LOW VERTICAL REAR FLUE ADAPTOR MIN. DIMENSIONS DEFAULT HEARTH MIN. DIMENSIONS TO WALL MIN. DIMENSIONS TO WALL 870mm 1070mm 1490mm 755mm 755mm 755mm 420mm 420mm 420mm 275mm...
  • Page 14: Corner Hearth Dimensions

    CORNER HEARTH DIMENSIONS ® VERTICAL REAR FLUE ADAPTOR Minimum dimensions to wall Minimum dimensions to wall ARC 7 STORE STAND/ LOW CORNER HEARTH WITH VERTICAL REAR FLUE ADAPTOR 755mm 755mm 275mm 275mm 420mm 420mm 458mm NON-COMBUSTIBLE MATERIAL Minimum thickness: 24mm Minimum thermal resistivity: 0.026 Installed in accordance with AS/NZS 2918:2018 3.3.2...
  • Page 15: Flue Clearances Diagram

    FLUE CLEARANCES DIAGRAM ® Summary of minimum height of flue sytem exit requirements from AS/NZS 2918:2018 6000 3000 More than 3000 or less 600 min. 3000 1000 min. if clear within 3000 of flue top Increase as necessary until nothing within 6000 of flue top Any nearby structure More than 3000 3000...
  • Page 16: Standard Default Triple Skin Flue Kit

    STANDARD DEFAULT TRIPLE SKIN FLUE KIT ® Cowl Flashing Optional 1000 Triple skin flue 1000 Ceiling Ring Dropbox 1000 Decorative Flue Solid OR Mesh 1000...
  • Page 17: Insulated Room Seal Flue Kit

    INSULATED ROOM SEAL FLUE KIT ® STANDARD FLUE KIT Cowl Room sealed flue (with locking band) 1000 Starter length flue 1000 Ceiling ring Room sealed flue adaptor 1000 Single skin flue Heatshield...
  • Page 18: Insulated Room Seal Flue Kit

    INSULATED ROOM SEAL FLUE KIT ® FULLY SEALED FLUE KIT Cowl Room sealed flue (with locking band) 1000 Starter length flue 1000 Ceiling ring 1000 Heatshield 1000...
  • Page 19: Insulated Room Seal Flue Kit

    INSULATED ROOM SEAL FLUE KIT ® REAR FLUE KIT Cowl Room sealed flue (with locking band) 1000 Gutter Wall Penetration Roof support brace min 25 Adjustable wall bracket Wall Plate Cleaning access Wall plate gal NOTE: 2700 There needs to be 50mm clearance to any timber above the flue pipe and a 25mm clearance to any timber to the side and underneath.
  • Page 20: Compliance Data

    COMPLIANCE DATA ® ARC 7 - COMPLIANCE DATA Compliance plate riveted onto rear heatshield...
  • Page 21: Arc 7 Dimensions

    ARC 7 DIMENSIONS ® To suit 150mm Optional rear flue adaptor PLAN VIEW (6”) flue pipe 1023 1040 FRONT SIDE REAR...
  • Page 22: Arc 7 Store Stand Parts List

    Charnwood Arc 7 Australia Parts List ARC 7 STORE STAND PARTS LIST Issue A ® 2a 36 Item Part No. Description Item Part No. Description 008/FW29 Door Seal Adhesive 010/KZ044 Air Control Slider Backing Plate 006/KZ018 Glass Inc. Seal 004/KZ043...
  • Page 23: Arc 7 Low Stand Parts List

    Charnwood Arc 7 Low Australia Parts List ARC 7 LOW STAND PARTS LIST Issue A ® 62 13 30 31 52 49 Item Part No. Description Item Part No. Description 008/FW29 Door Seal Adhesive 002/KZ053 Lower Hinge Bracket 006/KZ018 Glass Inc. Seal...
  • Page 24: Arc 7 Optional Drawer Parts List

    Arc 7 Drawer Kit Parts List 1st October 2020 ARC 7 OPTIONAL DRAWER PARTS LIST Issue A ® Item Part No. Description Ex.Vat. Inc.Vat. Item Part No. Description Ex.Vat. Inc.Vat. 010/KZ120 Drawer Kit (Optional Extra) ....196.00 235.20 004/KZ129R RH Drawer Support ......12.80 15.36 010/KZ127...
  • Page 25: Charnwood Australia 10 Year Guarantee

    • The following conditions apply: • If any part fails due to manufacturing or material defect within the guarantee period Charnwood will, free of charge, either repair or replace the part at their discretion. The decision of Charnwood is final.
  • Page 26 your premier dealer...

Table of Contents