Contents Introduction ... 3 Precautions ... 4 Remote Control Transmitter Controls and Functions ... 6 Battery Replacement ... 8 Remote Control Code Programming How to Program Remote Control Transmitters ... 9 Please write the serial number of the remote control below. Keep this booklet as a record of your purchase.
Congratulations on your purchase of this Honda Keyless Entry System. Your Honda Keyless Entry System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. The system consists of a remote control transmitter. The remote control allows you to operate from outside the vehicle while simultaneously locking and unlocking the doors.
Precautions Remote Control Range Several factors affect and reduce remote control range. Among these are: 1. Proximity to buildings and automobiles. 2. Proximity to high power transmitters (television, radio, cellular, HAM radio, etc.). 3. When the battery becomes weak, the remote control range becomes short.
Battery Power Use the remote control transmitter only when necessary. Every time a button is pressed, the remote control is consuming battery power. If battery is low on power, the transmitting range of the remote control will be affected. Check battery periodically and replace it when necessary.
Remote Control Transmitter Controls and Functions P A N I C • The doors cannot be locked or unlocked with the remote control transmitter when the key is in the ignition switch. • The doors cannot be locked if any one of the doors is open. •...
Remote Control Transmitter Battery Replacement Using a coin (Quarter) turn the battery cover counterclockwise and remove the cover from the back of the remote control. Remove the used battery. Make sure you install the new battery with the proper polarity. Note: •...
Page 10
Remote Control Code Programming P A N I C Press the "LOCK" or "UNLOCK" button on the remote control transmitter. Turn the ignition to the "OFF" (0, Ι) position. Turn the ignition to the "ON" (ΙΙ) position. Press the "LOCK" or "UNLOCK" button on the remote control transmitter.