Trouble Shooting - HoMedics PerfectSteam PS-250 Instruction Manual And Warranty

Trouble Shooting the Steamer
PROBLEM CAUSE
Steamer fails to heat Steamer not plugged in
ON/OFF switch not in
"ON" position
Auto shut off engaged
No steam Water level is low
Water drips from nozzle Condensation in hose
Nozzle gurgles Condensation in hose
Steam is intermittent Mineral build-up
SOLUTION
Plug in to electrical outlet
Push switch to "ON"
position. Switch will
illuminate.
Check water container to
ensure it is not empty. If
full, press the reset button
on side of unit. If empty,
refill and push reset to
begin.
Turn ON/OFF switch OFF
and refill water container
Hold the hose vertically
and allow water to drain
back into tank
Hold the hose vertically
and allow water to drain
back into tank
Follow the procedure for
removing mineral build-up
10
NOTE:
1. Water mineral content and conditions will vary in different areas. To insure continued
operation of the steamer, never store without cleaning and removing excess water from the
reservoir and water container.
2. If the reset light comes on with water in the tank you probably need to remove mineral build-
up.
3. In areas where the voltage exceeds 120V, it may be necessary to clean your unit more
frequently.
1 1