Hitachi BD-D120XGV Instruction Manual page 12

How to Install the Washer Dryer (Continue)
The symbol M is for checking whether you install the washer dryer correctly.
●
Connecting the water supply
Water supply hose
●
M Optimum water pressure is 0.03-0.8MPa.
M Do not connect to the mixer tap of an unpressurised hot-water apparatus.
M Use a horizontal tap.
* Model with SCREW TYPE water supply hose.
min. 10 mm
* Model with ONE TOUCH JOINT water supply hose.
1. Untighten the upper connector screw.
Upper connector
Fixing screw
In case the diameter of the tap is large, remove
●
the guide plate.
Guide plate
3. Connect the water supply hose to the middle
connector, pushing the plate down.
Middle connector
Water supply hose
12
Horizontal tap
M Connect the water supply hose to the rear panel of the washer dryer.
Make sure that the rubber seal is inside the hose connector.
M Firmly connect the water supply hose to the tap, and check connection points
for water-tightness.
Rubber packing
Middle connector
Connector
Extension tap
Hose connector
2. Push the upper connector up till the rubber
packing is in tight contact with the tap.
Then tighten the 4 screws.
Upper connector
Turn the middle connector so that there is
●
no water leak.
To separate the water supply hose from the
●
middle connector, turn off the tap, and then
pull the inlet hose down, pushing the plate
down.
Square tap
Rubber seal
Rubber packing
Middle connector