Advertisement
5. Function Settings
When PZ-62DR-E is used, the output signals from each terminal can be changed arbitrarily.
For how to change setting, please refer to the Lossnay installation and instruction manual.
6. Confirmation after Installation Work
After installation work is completed on the unit, follow the table below to perform inspection again. If there is a problem, be
sure to fix it.
Before a trial operation, be sure to confirm the following items and check the checkboxes.
□ Are the connection cables connected according to the connection diagram?
□ Is the connection load capacity within the maximum and minimum range?
□ Are the connection cables securely connected to the terminal block?
□ Are the connection cables arranged so that they are not touching the surface of the Lossnay unit control board?
□ Are any connectors on the circuit board disconnected?
□ Are the function settings set correctly?
7. Trial Operation
Conduct a trial operation following the installation and instruction manual for the Lossnay unit.
TOKYO BLDG. , 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
Advertisement
