Table of Contents
Advertisement
HDD/USB/FDD
If your system becomes unstable and you have loaded the BIOS default settings, you can use this function
File in HDD/USB/FDD
automatically created by the BIOS, such as reverting the BIOS settings to the last settings that worked
Before you begin
Windows 8/7 setup disk.
Motherboard driver disk.
A USB thumb drivev
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. Then connect the power connector from your power supply to the hard drive.
refer to Chapter 2, "BIOS Setup," "Integrated Peripherals."
Steps:
1.
to
Mode Selection to RAID. If you do not want to create RAID, set this item to IDE or AHCI.Turn on your
SATA Channel is enabled under Peripherals. Set OnChip SATA Type to RAID.
2.
settings and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
This mode supports Windows 8 64-bit installation only.
Step:
1. In BIOS Setup, go to BIOS Features and set OS Type to Windows 8 and CSM Support to Never. Save
the changes and exit BIOS Setup.
2. After the system reboot, enter BIOS Setup again. Then enter the Peripherals\Intel(R) Rapid Storage
Technology sub-menu.
, make sure SATA Controllers is enabled. To create RAID, set SATA
- 31 -
Select File in
Select
OnChip
Advertisement
Table of Contents
