Table of Contents
Advertisement
5) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
7
7
SATA3
5 4
3 2
1 0
1
1
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header
according to the pin assignments below. Note the positive and negative pins before connecting the cables.
Power
Power LED
Switch
Speaker
2
1
Hard Drive
Reset
Power LED
Activity LED
Switch
Chassis Intrusion
Header
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch,
power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this
header, make sure the wire assignments and the pin assignments are matched correctly.
Only for GA-Z87M-HD3.
Only for GA-H87M-HD3.
Pin No.
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
PLED/PWR
System Status LED
S0
On
S3/S4/S5
Off
PW
20
Connects to the power switch on the chassis front panel. You may
19
Speaker
Connects to the speaker on the chassis front panel. The system reports
system startup status by issuing a beep code. One single short beep
will be heard if no problem is detected at system startup.
HD
Connects to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
RES
Connects to the reset switch on the chassis front panel. Press the
to perform a normal restart.
CI
Connects to the chassis intrusion switch/sensor on the chassis that can
detect if the chassis cover has been removed. This function requires
a chassis with a chassis intrusion switch/sensor.
- 14 -
®
Z87 /H87
Connects to the power status indicator
on the chassis front panel. The LED is on
when the system is operating. The LED is
off when the system is in S3/S4 sleep state
Chipset
Advertisement
Table of Contents
