Accessories - Hitachi 42HDM12A Operating Manual

ACCESSORIES

Check to make sure you have the following accessories before disposing of the packing material.
REMOTE
CONTROL
CAUTION: Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
1. Remote Control Unit
2. Power Cord
3. D-SUB Mini 15-Pin Cable
4. Audio/Video Cable
5. S-Video Cables
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pressing the notched
part of the cover with your fingers and pulling the cover off.
2. Insert two new "AAA" size batteries for the remote control. When
replacing old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
POWER CORD
2.
BATTERIES
1. 6.
ventilation for the electronics or proper support for the front glass panel. This plasma monitor product
is designed for a maximum tilting angle of 45 degrees from vertical.
D-SUB MINI 15-PIN AUDIO/VIDEO
CABLE CABLE
3.
USER'S GUIDE EASY GRAPHIC
GUIDE
7.
6. Two "AAA" size, 1.5V batteries
7. User's Guide
8. Easy Graphic Guide
9. Warranty Card
8
S-VIDEO CABLE
4. 5.
WARRANTY CARD
8. 9.