Removing A Cassette; Protecting Recorded Material - Hitachi VM-E535LA Instruction Manual

Getting Started
1. Press the OPEN button to open the LCD monitor ("Opening the LCD Monitor", p19).
2. Slide the EJECT switch. "
cassette door will open automatically.
Caution: Be careful not to catch your fingers between the cassette door and the camcorder
as it could cut you.
Note: Cassette cannot be inserted or ejected unless the LCD monitor is open.
3. Place the cassette in the cassette holder so that the transparent window faces away
from the body of the camcorder and the sprockets toward the body of the camcorder.
4. Push the cassette holder, which is embossed PUSH LOCK on the left hand side, until
it "clicks" into place. The camcorder automatically closes.
Caution: Be sure that you push the cassette holder embossed PUSH LOCK to close the
holder. Otherwise, the holder will not click into place and the tape may be slack which could
lead to damage.
Note: If "TAPE" flashes in the viewfinder or LCD monitor, remove the cassette and check
that the tape is not damaged, is not slack or no dust adheres to it, etc. After making sure
that there is no abnormality, reinsert the cassette. If "TAPE" reappears, see
"Troubleshooting" on page 53.

Removing a Cassette

Press the EJECT switch. "
door opens automatically. Remove the cassette.

Protecting Recorded Material

Protect 8mm cassettes from accidental erasure by sliding the tab on the side of the
cassette towards the opposite side until the tab is completely visible. Slide the tab in the
opposite direction, until the tab disappears, to record on the cassette again.
EJECT" will appear on the LCD monitor, and the
EJECT" will appear on the LCD monitor, and the cassette
23