Before First Use - Champion CHRS310 User Manual

Parts
1. Pushing bar
2. Transparent cover
3. Juicing net
4. Middle ring
5. Handle
6. Residue barrel
7. Main body
8. Juice jug

Before first use

1. This machine is equipped with safety unit, when the handle does not fasten the cover or the
cutter seat is not fastened, the motor cannot start.
2. When disassembling or assembling the juicer, press the upper of feed port of the cover with
your hand, then force the handle to slide in or out of cover slot.
3. When disassembling juicing net, first remove the cover and residue barrel, then turn the middle
ring up to 30 degrees by holding juicing nozzle with your hand.
4. Clean all parts able to disassemble (refer to the section of "maintenance and cleaning").
5. When assembling, see section "parts".
6. When using for the first time there may be slight smell from motor, this is normal, after the has
worked for some time, this phenomenon will disappear.
7. In order to prolong service life of machine, over-temperature protective device is mounted in
the motor. If the motor works for a long time or overloaded, when over warning temperature,
power supply will automatically cut off. After the motor stops, pull out plug of power supply, wait
for the motor to cool (about for 30min), use again.
Juicing
2. Accelerator Key
3. Pulse key
1. Before juicing, confirm that the juicing net and rotor is clutched in position. Put the transparent
cover on, fasten tight the handle, then turn on the machine.
2. Before using, make sure the button switch of the main machine in stop state, in this way, in case
assembly is not completed, starting the main machine can be avoided to make sure safe opera
tion.
3. Before juicing, first confirm juicing net and rotor are clutched in position, and that there is no hard
contact between juicing net cutter and transparent cover.
4. Put the transparent cover in place, put the handle into the cover slot, then turn on the machine.
1. Screen
4. Declaration key
5. ON/OF key
EN
2