Makita DTD154 Instruction Manual page 8

Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Fig.5: 1. Lamp
Fig.6: 1. Button
release it. The lamp goes out approximately 10 seconds
after releasing the switch trigger.
To keep the lamp off, turn off the lamp status. To turn off
seconds.
To turn on the lamp status again, press the button again
similarly.
NOTE:
on, the lamp status is OFF.
NOTE:
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Changing the impact force
Fig.8: 1. Changed in four steps 2. Hard 3. Medium
4. Soft 5. T mode 6. Button
This allows a tightening suitable to the work.
"T" is a special mode for fastening self drilling screws. In this mode, the tool starts to drive a screw with faster rota-
tion, which is suited for drilling with the self-drilling-screw tip. Once the tool starts to tighten the screw, it impacts in
medium force grade.
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Impact force grade displayed
on panel
Hard
T S H
Medium
T S H
Soft
T S H
T mode
T S H
for one second within 10
is pressed, the number of blows changes in four steps.
Maximum blows
-1
3,800 min
-1
2,600 min
-1
1,100 min
-1
2,600 min
Reversing switch action
Fig.7: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
tion, the switch trigger cannot be pulled.
Purpose
Tightening when force and
speed are desired.
ing is needed.
Tightening with less force to
avoid screw thread breakage.
Tightening when speed and
8 ENGLISH
Example of application
Tightening underwork mate-
rials, tightening long screws,
tightening bolts.
-
plaster boards.
Tightening sash screws, tight-
ening small screws such as M6.
Tightening self drilling screws.
-
-