EMS FireCell FC-171-001 Installation Manual

Wireless Beacon
Installation Guide
1 Pre installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device, as this will cause communication with the Control
Panel to be lost. Should this happen, delete the device from
the system and add it back on.
This device contains electronics that may be susceptible to
damage from Electrostatic
appropriate precautions when handling electronic boards.
3 Fix mounting plate
Remove the mounting
ANTICLOCKWISE, to release it from the mounting plate.
When wall mounting, ensure the mounting plate is fitted in the
orientation shown.
Use both fixing positions to ensure a firm fixing.
Use suitable fasteners and fixings.
5 Optional device locking
To lock the beacon into the
wireless module, remove
the cut out section as
shown.
To unlock, insert a 1.5
mm allen key to depress
the locking clip and turn
anticlockwise to release
as shown.
©2021 EMS Ltd. All rights reserved
Example shown:
FC-323-CA1
FC-171-001
Discharge (ESD).
plate by turning the
63 mm
THIS WAY
UP WHEN
WALL
MOUNTING
Cut out section
(shaded area)
Part no
FC-171-001
FC-171-002
FC-323-CA1
FC-323-CA2
FC-323-WA1
FC-323-WA2
See the Specification section for compliance information.
2 Components
1
Take
3 Battery retaining plate
4 Power device
Unclip the battery retaining plate from the wireless module.
device
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
Once powered, reassemble the device.
6 Configuration
The device's loop address is configured within the user interface's
menu structure.
Refer to the programming manual for full programming details.
FireCell = MK98
Fusion = TSD062
WZM = TSD143
Free to download from
www.emsgroup.co.uk
Page 1 of 2
Product description
White Wireless Sounder Base Only
Red Wireless Sounder Base Only
White Ceiling Beacon Only
Red Ceiling Beacon Only
White Wall Beacon Only
Red Wall Beacon Only
2
1
2
Beacon Wireless module
4 Mounting plate
SIZE AA
(both pins linked)
TSD068-99 Iss 8 24/11/2021
CPR
[2]
[2]
[1]
[1]
[1]
[1]
3
4
device
unpowered
(pins unlinked)
device
powered
AJM