Operation - Ryobi CRP-1801/DM User Manual

GB
F D
PRODUCT SPECIFICATIONS
Blade Stroke
Motor
Maximum Cutting Thickness (wood) 60 mm
No Load Speed
Switch
FEATURES
1. LOCK-OFF BUTTON
2. DEPRESS HERE TO PULL SWITCH TRIGGER
3. SWITCH TRIGGER
4. BLADE CLAMP LOCK / RELEASE LEVER
5. SAW BLADE
6. BASE (SHOE) ASSEMBLY
7. BATTERY PACK (NOT INCLUDED)
8. LATCHES
9. DEPRESS LATCHES TO RELEASE
BATTERY PACK
10. BLADE CLAMP
11. TON INSTALL/TO RELEASE
12. TO LOCK
13. BLADE SHOWN CORRECT IN SAW BAR

OPERATION

WARNING
Always remove battery pack from your saw when
you are assembling parts, making adjustments,
assembling or removing blades, cleaning,
or when not in use. Removing battery pack will
prevent accidental starting that could cause
serious personal injury.
TO REMOVE / ATTACH BATTERY PACK
(NOT INCLUDED)
See Figure 2.
TO REMOVE
Locate latches on side of battery pack and depress
■
both sides to release battery pack from your saw.
Remove battery pack from your saw.
■
TO ATTACH
Place the battery pack in your saw aligning raised rib
■
on battery on battery pack with groove in saw's
battery port. See figure 2.
E I P NL
18V
22 mm
18 V
0-3000 min
Variable Speed
S DK N FIN GR
English
Make sure the latches on each side of the battery
■
pack snap into place and battery pack is secured to
saw before beginning operation.
TO INSTALL SAW BLADE
See Figure 3.
Remove battery pack. See figure 2.
■
-1
Lift blade clamp lock/release lever on side of saw.
■
Insert saw blade between blade clamp and saw bar.
■
Lock blade clamp lever.
■
Replace battery pack.
■
GENERAL CUTTING
See Figure 4.
Hold your saw firmly in front of and clearly away from you.
Make sure saw blade is clear of any foreign material.
Be sure material to be cut is held firmly. Small work pieces
should be securely clamped in a vise or with clamps to
the work bench or table. Mark the line of cut clearly.
Depress the lock-off button, then pull switch trigger to start
the cutting action. Place the base assembly against the
work, then move the blade into the work. Do not force.
Use only enough pressure to keep the saw cutting.
Let the blade and saw do the work. Use of excessive
pressure that causes bending or twisting of the blade
may result in broken blades.
PLUNGE CUTTING
See Figure 5.
Mark the line of cut clearly. Choose a convenient starting
point inside the area to be cut out and place the tip of the
blade over that point. Rest front edge of base assembly
on work and hold firmly in position. Depress the lock-off
button, then pull switch trigger to start the cutting action.
With saw blade at full cutting speed, slowly tilt saw
downward until tip of blade starts cutting work.
After blade penetrates work, tilt saw until blade is
perpendicular to the work.
5
H CZ RUS RO
WARNING
Failure to remove battery pack from saw could
result in accidental starting causing possible
serious personal injury.
WARNING
Make sure blade does not touch work until motor
reaches full speed, since this could cause loss of
control resulting in serious injury.
PL SLO HR TR