Table of Contents
Advertisement
iMPOrTanT
If you hear a noticeable change in the pitch of
the cleaner. This indicates a need to empty the
dirty water tank.
USE THE WASH TOOl
EmPTY THE DIRTY WATER TANk
1. Grasp the top of the
dirty water tank handle and
press the release latch.
4. To empty the water tank
grasp the handle with one
hand and the nozzle with
the other and empty into
the sink.
CaUTiOn
Don't over saturate your upholstery.
(SOME MODELS ONLY)
1. Turn power switch on and brush
switch off. While depressing the solution
spray trigger, push attachment in
forward motion. Release trigger and pull
attachment backwards over the same
path to remove dirty water and solution
from upholstery. (For heavily soiled
areas, repeat if necessary).
2. Pull the dirty water tank
up out of the base, taking
care to ensure that no dirty
water leaks from the front.
IMPORTANT: Empty and rinse out clean and dirty water tank and leave to air
dry before replacing. Do not leave solution stored in tank between uses.
IMPORTANT: The fl oat in your carpet washer will shut off suction when the
dirty tank is full. For best results, use a smooth steady motion, keeping the
nozzle fl at against the carpet. Once the fl oat is activated, empty the dirty
water tank. If the tank does not appear full, turn off the power switch and
wait for the fl oat to settle.
3. Remove dirty water
tank lid.
13
Advertisement
Table of Contents
