Table of Contents
Advertisement
Sub-menu
To select the settings you require,
press the buttons below the symbols
until the required setting is selected
in the display.
To select the settings you require,
press the buttons below the symbols
until the required setting is selected
in the display.
If a setting is activated, the display
shows
. The selection does not
need to be confirmed again.
The sub-menu closes automatically
after a few seconds.
Before using for the first time en
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press
.
1.
The switch-on process takes a few
seconds.
Set the Drum clean programme.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
Add washing powder to the
5.
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press Start/Reload
7.
programme.
a The display shows the remaining
programme duration.
Start the first wash cycle or press
8.
to switch off the appliance.
→ "Basic operation", Page 32
to start the
19
Advertisement
Table of Contents
