Description Of Symbols - Lea 11099-40A3 Original Operating Instructions

Emissions
-- The specified vibration emission value was measured by a standardized test methods and
can compare with other power tools are used.
-- The specified vibration emission value can also be necessary for the assessment of work
breaks are used.
-- The specified vibration emission value can vary during the actual use of the electric tool by
specifying the value, depending on the way how to use the power tool.
-- Note: You create the privilege against vascular pulsations of the hands in time breaks
Keep the development of noise and vibration to a minimum!
• Only use properly functioning machines.
• Maintain and clean the machine regularly.
• Adapt your working method to the machine.
• Do not overstress the machine.
• If necessary, have the machine inspected.
• Switch the machine off when it is not in use.
• Wear work gloves.
Wear hearing protection. The influence of noise can cause hearing loss.
Noise emission information in accordance with the German Product Safety Act (ProdSG) and
the EC Machine
Directive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the
operator will require noise protection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the local regulations when operating
your device.

3. DESCRIPTION OF SYMBOLS

The use of symbols in this manual is intended to draw your attention to possible risks. The
safety symbols and the explanations that accompany them must be perfectly understood. The
warnings in themselves do not remove the risks and cannot replace correct actions for
preventing accidents.
WARNING
23