Pride Jazzy 614 Technical Troubleshooting Manual page 7

8. Remove the front shroud. See figure 6.
9. Unplug connector 3a from connector 2a. See diagram 2.
10. Measure voltage across pin 1 and pin 4 on connector 2a.
See figure 7.
— If the multimeter indicates 0VDC, then go to the next step.
— If the multimeter indicates greater than 0VDC, then
replace the Dynamic bus cable extension (3) and retest
the system.
11. Unplug connector 5a from connector 2d. See diagram 2.
12. Measure voltage across pin 1 and pin 2 on connector 5a.
See figure 8.
— If the multimeter indicates 0VDC, then go to the next step.
— If the multimeter indicates greater than 0VDC, then
replace the Dynamic power module (2) and retest the
system.
13. Unplug connector 6a from connector 5b and connector
7a from connector 5c. See diagram 2.
MANDATORY!
terminals, and related accessories
contain lead and lead compounds.
Wear goggles
handling batteries and wash hands
after handling.
WARNING!
batteries from freezing and never
charge a frozen battery. Charging a
frozen battery may result in damage to
the battery.
WARNING! RED (+) cables must be
connected
terminals/posts.
must be connected to negative (-)
battery terminals/posts.
caps should be installed over all
battery terminals. REPLACE cables
immediately if damaged.
14. Measure voltage across pin 1 and pin 2 on connector 6a.
See figure 9.
— If the multimeter indicates greater than 0VDC, then go
to step 16.
— If the multimeter indicates 0VDC, then go to the next step.
Jazzy 614 with Dynamic Electronics Technical Troubleshooting Guide
Battery posts,
and gloves when
Always protect
to positive (+) battery
BLACK (-) cables
Protective
Figure 6. Front Shroud Removal
the
Figure 7. Connector 2a
Figure 8. Connector 5a
Figure 9. Connector 6a
1 2
3 4
Measure Voltage
Measure Voltage
1 2
1 2
Measure Voltage
www.pridemobility.com 7