O-Mac MF 2500 Manual page 66

IX. Storing
the machine
IMPORTANT The safety regulations to
follow for putting into storage are described
in paragraph 2.4. Strictly comply with these
instructions to avoid serious risks or hazards.
If you are not going to use the machine
for a period of more than 2-3 months, we
recommend you do a few things before
putting it away. This will make it easier when
you want to use the machine again and will
also prevent permanent damage to the
engine.
Before putting the machine away:
1. Unscrew the two clutch housing nuts,
remove the housing and remove the chain
and bar.
2. Empty the oil tank, fill with about 100-120
cc of specific liquid detergent and plug the
cap.
3. Fit the guard back on without tightening
the nuts.
4. Start the engine and keep it running until all
detergent is used.
5. Start the engine and run it idle until it uses
up all the fuel that is left in the tank and the
carburettor.
6. Wait for the engine to cool.
7. Remove the spark plug.
8. Pour a teaspoon of (new) 2-stroke engine
oil into the spark plug slot.
9. Pull the starter hand grip several times to
deliver oil to the cylinder.
10. Replace the spark plug with the piston in
the dead end upper position (visible from the
spark plug slot when the piston is at maximum
stroke).
11. Clean the machine thoroughly.
12. Check the machine for any damage. If
66
necessary, contact the Authorised Service
Centre.
13. Store the machine: –– in a dry place
– protected from inclement weather
– with the bar cover guard fitted correctly
– in a place where children cannot get to it
– making sure that keys or tools used for
maintenance are removed.
Before starting to use the machine again:
1. Remove the spark plug.
2. Pull the starter hand grip a few times to
eliminate excess oil.
3. Check the spark plug (par. 8.5).
4. Arrange the machine (par. 4.2 chap. 6)
X. Handling and
transportation
When handling or transporting the machine,
always:
– stop the machine (par. 6.6).
– wait until the chain is stationary.
– remove the spark plug cap (Fig. 31.A).
– mount the bar cover.
– only hold the machine using the hand grips
and position the bar in the opposite direction
to that used during operation.
When transporting the machine on a vehicle,
always:
– position it so that it does not cause a hazard
to anyone;
– fasten firmly to the means of transport using
ropes or chains to prevent it from tipping over
causing damage and fuel leaks.