Stack-On SS-22-MG-C Instructions Manual

SS-22-MG-C
SS-22-MB-C
SS-16-MG-C
SS-16-MB-C
SS-10-MG-C
SS-8-MG-C
WARNING
Serial #
Hardware Included:
(2) M10x70 Lag screws
(2) washers
(2) plastic anchors
IMPORTANT:
• Record the serial number from the tag on the
back of the safe or from the tag on the front
bottom corner of the safe.
• Keep this record of your combination in a
secure place away from children.
• Do not store this document in the safe.
• Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
• Warning: Keep your safe closed and
locked at all times when not in use. Children
could accidentally be locked inside the safe.
®
Instructions
Tip Over Hazard
A child or adult can tip the safe and
be killed or seriously injured.
Failure to secure the safe as shown in
these instructions can result in death
or serious injury to children and adults.
Children should not play with or
around the safe at any time.
Tools required:
drill
7/16" drill bit
3/8" drill bit
17mm socket wrench
Phillips screwdriver.
Your Combination Number
1st
3 times (R)
2nd
2 times (L)
3rd
1 time (R)
SAFE COMBINATION INSTRUCTIONS
All numbers must be dialed exactly. If you pass a
number, you can not back up. You must start over.
All numbers are to be dialed to the Top Notch located
on top of the dial ring (the 12 o'clock position).
combination number twice landing on the
number the third time.
2. Now turn the Dial counterclockwise, passing the
second combination number once landing on
the number on the next time around.
3. Turn the Dial clockwise until you reach the third
combination number.
handle clockwise. Pull the door towards you.
Example: If the dial combination numbers were 70 - 50 - 30
1st
70
3 times
HOW TO LOCK
1. Close the door.
2. Turn the handle to the locked position.
3. Turn the dial either direction a few rounds.
3rd
2nd
30
50
twice once
40247-2203
1
15