Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for ETS 850
Summary of Contents for ETS 850
- Page 1 SURFACE RESISTANCE PROBE MODEL 850 OPERATING INSTRUCTIONS D01566 Rev A...
- Page 2 2.0 SET UP The Model 850 Probe has a standard 0.162’ (4mm) banana jack in the top for connection with a standard banana plug. The Probe is connected to the resistance meter as shown in Figure 1 for resistance to ground measurements (RTG) and in Figure 2 for point-to-point resistance (pt-pt) measurements.
- Page 3 Figure 3: Point-Point meter connection The Probe can only be used on smooth, flat surfaces. To make a measurement, place the Probe(s) on the surface in accordance with the layout or spacing specified in the standard being used. Apply the test voltage for several seconds and then take a reading.
- Page 4 3.0 WARRANTY Limited Warranties. Seller warrants that all goods manufactured and delivered hereunder shall (a) conform to any samples, drawings, specifications or other written documents provided to Seller by Buyer, or approved by Buyer to Seller and (b) be free from all defects in workmanship and material. Buyer’s sole remedy against Seller for breach of either of the specifically mentioned warranty shall be the repair or replacement, at Seller’s sole option, of the defective workmanship or material.
Need help?
Do you have a question about the 850 and is the answer not in the manual?
Questions and answers