Listening To The Radio; Dual Alarms Operation - Dcybel Clockwise Instruction Manual

LISTENING TO THE RADIO

1. To turn on the radio, press
2. Tune in to the desired station by repeatedly pressing
 The wire aerial located on the rear of the unit is for FM reception. The wire should be fully
extended and positioned for optimum reception.
 Press and hold
will scan the frequencies until a broadcasting station strong enough for good reception is found.
 Automatic search: Press
automatically store them to the radio preset locations.
3. Repeatedly press
4. To turn off the radio, press
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 20 FM radio stations can be preset.
1. Follow steps in "LISTENING TO THE RADIO" and tune in to the station that you wish to preset.
2. Press and hold
3. Repeatedly press
4. Press again to store the station.
5. Repeat steps above to store desired stations.
To listen to preset radio stations, repeatedly press

DUAL ALARMS OPERATION

Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 and/or Alarm 2
1. In standby state, press and hold
 The alarm symbol
2. While the hour digit is flashing, repeatedly press or press & hold
3. Press
 The minute digits will flash on the display.
4. While the minute digits are flashing, repeatedly press or press & hold
the minutes.
/
/
until "P" with a flashing number "01" is shown on the display.
/ to select the desired memory slot.
/ will appear on the display.
/ to confirm.
.
/
for about 2 seconds and then release the button, the unit
. Your clock radio will auto scan for FM radio stations and
to adjust the volume.
.
to select the desired radio station.
/ until the hour digit flashes.
.
/ to set the hour.
/ to set
EN-3