Adjusting The Angle Of The Expander; Safety; Storage And Transport; Moving - Pronomic Expand&Turn Light User Manual

3.3 Adjusting the angle of the expander

The expander can be adjusted to compensate for the weight of the roll and/or the circumstances
around loading/unloading. This is done by loosening the assembly bolts(see drawing, Chapter 1),
do not remove the bolts. Adjust the angle using the setscrews. Tighten the bolts/nuts.

4 Safety

The operator should use personal safety equipment (e.g. protective shoes) that handling the
specific goods requires.
Stated maximum load must not be exceeded.
Be aware of the risk of crushing present between the attachment and the trolleys legs or the floor
when raising or lowering the load. Avoid putting hands or other parts of your body under the load
at all times.

4.1 Storage and transport

If the attachment is attached to a trolley when transported, the trolley should be carefully tied
down to minimize the tipping risk.
If the attachment is transported separately it should be carefully packed to protect the expander.

4.2 Moving

The attachment should always be lowered to the lowest possible position before moving the
trolley to have the safest and most stable handling possible. Be cautious when passing thresholds,
cables and other objects on the floor.

4.3 Loading and unloading

The operator is responsible for the correct use of the attachment. Do not place any hands or feet
under a rotating load. Always rotate in the direction away from you.

5 Maintenance

5.1 Every day

Wipe the attachment clean if it is dirty. Do not use water or pressure washers.
Check the expander block and make sure I slides out of the core when activated.

5.2 Every day, or when needed

Check the screws holding holding the expander on the trolley
________________________________________________________________________________
4 – Expand&Turn - Light 17940