Table of Contents
Advertisement
3.1.2 Loading rolls laying down or from a prong
Turn the setting pin to green (active mode).
(Active mode can also be set after the expander core is inside the roll)
Position the expander to the prong or the core of the roll and activate the brakes on the trolley.
Slide the roll onto the expander completely. The expander block will slide back but instantly lock
the roll when rotated.
Notice! – Do not place any hands or feet under a rotating load. Always rotate in the direction
away from you.
3.2 Unloading rolls
To unload a roll the setting pin needs to be set to red (inactive mode). This can be done if the roll
is pushed in all the way on the expander pressing the expander block back or if the expander block
is pulled back by hand.
3.2.1 Unload rolls standing
(In active, green mode)
Lower the roll on a surface. Continue to lower the expander until the expander block is in its end
position. The Lift&Drive slipping clutch will prevent the tool from being lowered to far. Turn the
setting pin to read (inactive mode), this will prevent the expander block from sliding out.
In cases where the roll is too short the expander block needs to be pulled back by hand. Pull the
block all the way back and then turn the setting pin to red (inactive mode). The expander can now
be removed using the controls for the trolley.
3.2.2 Unloading rolls laying down onto a prong
(In active, green mode)
Position the expander to the prong or the roll to the surface, activate the brakes on the trolley.
Make sure that the roll is pushing the expander block all the way back. Turn the setting pin to red
(inactive mode), this will prevent the expander block from sliding out. Slide the roll of the
expander by hand onto the prong or by moving the trolley when unloading on a surface.
________________________________________________________________________________
3 – Expand&Turn - Light 17940
Advertisement
Table of Contents
