Aurora HID WALKOVER Instructions

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE
USING THIS INSTRUCTION LEAFLET
This instruction leaflet has been designed as a general installation guide to help you install your particular outdoor
luminaire. Please pay particular attention to how your luminaire is wired. If you require any guidance or any further
information regarding your outdoor luminaire, please contact us via the details below or visit our web site.

IMPORTANT INSTALLATION INFORMATION

Installation should be carried out in accordance with the latest edition of the I.E.E. Wiring Regulations (BS7671) and
•
taking into consideration the latest Building Regulations. If in doubt, consult a qualified electrician.
Before commencing any installation or maintenance work, ensure electricity is switched off at the mains.
•
Please take note of the maximum rated voltage for your luminaire.
•
Please take note of the IP (Ingress Protection) rating of your luminaire when deciding location.
•
Always allow sufficient slack in the supply cable in order to remove the luminaire from its position for any future
•
maintenance.
Please take note of the maximum lamp wattage for your luminaire as detailed on the product label.
•
Ensure that ALL electrical connections are tight with no loose strands, including factory made connections.
•
Care must be taken for installations where the lens or bezel may come into contact with bare skin.
•
All luminaries run HOT. It is the installer's responsibility to consider fire & safety risks and take appropriate precautions.
•
Please take note of the nearest illuminated surface as detailed on the product label.
•

IMPORTANT USER INFORMATION

Always switch off mains supply before installation, servicing, fitting or changing the lamp.
•
Replace failed lamps immediately. Allow the lamp and fitting to cool before replacing lamp. Check that the correct lamp
•
type and wattage is fitted. Dispose of failed lamps correctly.
HID (High Intensity Discharge) lamps must not be touched by bare hands- use a cloth or glove.
•
HID luminaires are NOT dimmable.
•
Replace any cracked protective glass immediately and use only original parts to do this.
•
It is recommended to clean every two to three months to preserve the finish of this product. Do not use solvents or
•
aggressive cleaning agents.

GENERAL INSTALLATION - SAFETY

When positioning your luminaire, please take note that outdoor electrical installations should be installed by qualified
electricians. Electrical equipment in the garden can be lethal if incorrectly installed or if inadequate provisions have been
made in the event of an equipment fault. Water is the main threat. It can seep in through joints and gaskets; it can be drawn
into electrical enclosures by capillary action; and it can penetrate ageing materials which corrode, crack or are damaged by
wildlife, pets, children, careless gardening or just time. Water conducts electricity and as the ground is usually damp to
some extent, the contact of human feet with the ground is all that is needed to provide a fatal route for electrical current.
Proper circuit protection for all exterior electrical services should include a residual current device (RCD), also known as an
earth leakage circuit breaker (ELCB). This simple device ensures that the power is cut off immediately; it detects a leakage
of current to earth, which indicates an electrical fault which is potentially threatening to life. Observe these few simple rules
and keep your outdoor electrical installation safe.
OUTDOOR LIGHTING – HID WALKOVER LIGHT
IP67