Aurora DECKLIGHT Installation

Installation Instructions

*Read and understand the instructions completely. Be sure electrical current is turned off. In you have

any doubts about how to install this fixture, please contact an electrical contractor.

Be sure to follow all

applicable local building codes for installation and wiring of low voltage lighting.

Do not exceed the total wattage output of the transformer being used. To determine this, multiply the

total number of lights being used times the watts per light (7 watts in model ALA2048 and ALA3048).

This is the total wattage needed. Exceeding the total wattage will cause the bulbs to appear dimmer than

intended and destroy the transformer. Caution: Under sizing the transformer could create a fire hazard!

Do not oversize the transformer. This will shorten the bulb life and make the fixture appear brighter than

is intended. Do not exceed recommended wire runs as listed in your transformer instruction sheet.

Follow wiring recommendations as listed in transformer instructions.

Install 12 gauge, UV rated two conductor low voltage wire per installation instructions provided by your

transformer manufacturer. Do not connect the low voltage wire to the transformer until all lights have

been installed and connected to the low voltage wire. Connect one model DLE4410 (60" long), or

DLE4420 (96" long) Pigtail to the low 12 gauge low voltage wire at each light location. Press wire straight

down into the connector pins. Check for "bulge" on both sides of the wire. Secure cover plate with three

screws. Connect male-female leads from the Pigtail to the Decklight. (Push the "quick connectors"

together). Follow these steps to connect each Decklight to the low voltage wire. Once all lights are

installed, attach the low voltage wire to the transformer as noted in installation instructions included with

the transformer. Plug the transformer into a grounded 110v outlet. Turn power on, confirm light is on.

Table of Contents

Do you have a question about the DECKLIGHT and is the answer not in the manual?

Page 1 Connect male-female leads from the Pigtail to the Decklight. (Push the “quick connectors” together). Follow these steps to connect each Decklight to the low voltage wire. Once all lights are installed, attach the low voltage wire to the transformer as noted in installation instructions included with...
Page 2 VPI Decklight Company warrants this product against defects in materials or workmanship as follows: For the first year from the date of purchase, VPI Decklight Company will repair or replace the unit, at our option, without charge for parts or labor. After the indicated period of one year, the product owner is subject to pay repair and parts fee.