Subscribe to Our Youtube Channel
Related Manuals for TSI Instruments TG-80
Summary of Contents for TSI Instruments TG-80
- Page 1 & & TG-80 TIRE GROOVING STATION TG-80 TIRE GROOVING STATION R E A D I N S T R U C T I O N S T H O R O U G H LY B E F O R E O P E R AT I N G...
- Page 2 TG-80 TIRE GROOVING STATION SAFETY INSTRUCTIONS WARNING: Only Personnel Trained in the TG-80 Should Be Operating This Machine. Thoroughly Read All Safety and Operating Instructions Before Using This Machine. Grooving Tool Hanging Hook Grooving Gun Cooling Sheath for Cable Support Tube...
- Page 3 TG-80 TIRE GROOVING STATION SET UP SET-UP INSTRUCTIONS Remove solid reservoir plug in rear of machine and replace with reservoir breather. Check oil level. Keep full to breather level with ATF, and change fluid at 6 month Insert upper control arm intervals.
- Page 4 TG-80 TIRE GROOVING STATION SET UP SET-UP INSTRUCTIONS Insert grooving cutter into grooving head. Depending on width of groove desired, a variety of cutters are available. Choose width as desired. After grooving cutter is installed, tighten locking screws to retain the cutter.
- Page 5 TG-80 TIRE GROOVING STATION OPERATING INSTRUCTIONS INSTRUCTIONS To begin grooving, tire must be Open ball valve approximately placed on holding arms. To activate 1/8 to ¼ turn to allow a small hydraulic system, push start button. airflow. The air flows through...
Need help?
Do you have a question about the TG-80 and is the answer not in the manual?
Questions and answers