BASIC OPERATION
1.
Clean machine table and/or base
•
Remove any metal bits, chips, or machining swarf
2.
Begin with a clean DynoMount assembly
•
Remove any metal bits, chips, or machining swarf
3.
Set the DynoMount mount on to the machine table or to the appropriate 52/96 family base that
is mounted to the machine table
4.
Attach DynoMount to machine table or base with appropriate mounting method
•
All DynoMount mounts come pre-installed with pull studs
except M90T4-668 (DynoMount 96 family) Tombstones
•
See your machine operation manual for specifications
to install M90T4-668 (DunoMount 96 family) Tombstones
5.
DynoMount is ready to accept a base installation
•
Clean and lightly oil contact surfaces for optimum operation
•
Remove M10 socket head cap screw if not removed and set aside
•
Align base counter bored mounting locations with bushings
•
Insert M10 socket head cap screw and turn clockwise with M8 hex wrench until tight
•
Torque cap screws to 87 Nm or 64 ft-lb.