Page 1
WORKHOLDING DYNOLOCK™ QUICK START GUIDE ENGLISH DYNOLOCK™ BASE Quick Start Guide...
Page 2
We know that proper and timely information is key to successfully doing your job. To support your success, Mate provides all the information you need — at your fingertips — when and wherever you need it. To get started, scan one of the QR codes below or scan the QuickSpecs™ 2D bar code on the vise itself.
Page 3
USING QUICKSPECS ™ The Mate 52/96 zero point workholding system includes QuickSpecs™, a unique product identification system that provides real-time access to product information and potential integration into your business systems. Simply use your smart phone and scan the 2D bar code on the side of the product.
BASE OVERVIEW: Lifter Lifts Vise from Base Pull Stud Pocket 2D Bar Code Designed to fit Mate Pull Studs For quick access to QuickSpecs™ Poka-Yoke alignment feature Compatible with M5 x 6mm cap screw Table Mounting Bore “R” Pull Bar...
Page 5
FIRST USE & BASIC OPERATION Your Mate DynoLock Base comes ready to use right out of the box and in the open position. Clean machine table • Remove any metal bits, chips, or machining swarf Begin with a clean base assembly •...
Page 6
BASIC OPERATION (CONT.) Prepare base for vise installation • The base should always be in the fully open position when a vise is not installed. Ò DO NOT close base without a vise or top tool present • Verify that the base is fully open by turning the socket adapter with a 6mm hex key counter-clockwise until the hex key stops Ò...
Use NLGI Grade 2 Li-based grease with MoS2 (MobilGrease XHP 322 Mine or similar) INSTRUCTIONS/ ADDITIONAL INFORMATION MAINTENANCE For assembly instructions and more, consult the DynoLock instructions by going to mate.com/wh or for fast access — scan the QR code at right to download.