Advertisement
Quick Links
Advertisement
Related Manuals for MATE DYNOGRIP VISE
Summary of Contents for MATE DYNOGRIP VISE
- Page 1 WORKHOLDING DYNOGRIP™ QUICK START GUIDE ENGLISH DYNOGRIP™ VISE Quick Start Guide...
- Page 2 THANK YOU FOR YOUR PURCHASE Proper and timely information is key to successfully doing your job. To support your success, Mate provides all the information you need — at your fingertips — when and wherever you need it. To get started, scan one of the QR codes below or scan the QuickSpecs™ 2D bar code on the vise itself.
- Page 3 USING QUICKSPECS ™ The Mate 52/96 zero point workholding system includes QuickSpecs™, a unique product identification system that provides real-time access to product information and potential integration into your business systems. Simply use your smart phone and scan the 2D bar code on the side of the product.
- Page 4 VISE OVERVIEW: Jaws are not a matched set and can go on either pusher in either direction External Hex on left end of vise 52 family 12mm 96 family 16mm Right Hand Thread Pusher (Only use external hex to torque vise) Indicated with R 6mm internal hex on both ends of leadscrew for speed travel...
- Page 5 Your Mate DynoGrip Self-Centering Vise comes precision tuned and ready to use right out of the box. If your use differs from the standard installation, please consult the DynoGrip instructions by going to mate.com/wh or for fast access — scan the QR code on page 1 of this guide.
- Page 6 PROPER PART LOADING Single Station Self-Centering Jaw Configuration: • It is important to symmetrically load single or multiple parts axially on-center to the vise to avoid excessive jaw twist • Individual part clamped sides should be within .15mm (.006”) parallelism for clamping on smooth jaw surface and within .51mm(.020”) when using the grips to provide secure part retention •...
- Page 7 REVERSE FORCE CLAMPING SETUP To switch from inward clamping to reverse force clamping: Remove the pushers from the leadscrew Keeping each pusher on the end it was removed from, rotate each pusher so that the top hook feature faces away from the vise center Thread the pushers simultaneously back onto the leadscrew Install the jaws in desired orientation Center the jaws per the vise calibration procedure (see instructions)
- Page 8 GLOBAL COVERAGE WORLDWIDE HEADQUARTERS: 1295 Lund Boulevard, Anoka, Minnesota 55303 USA Tel +1.763.421.0230 mate.com orders@mate.com Copyright © Mate Precision Technologies Inc. All Rights Reserved. All trademarks and trade names are the property of their respective owners. LIT01427 Rev A 2021...