Use - Klarstein MARCIA Manual

Nut milk maker
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 17

USE

Preparation of a drink
1.
Connect the appliance to the power supply.
2.
Turn on the appliance by tapping the Start/Cancel button. The display now
lights up.
3.
You can select the various programmes with the Select button. Press the
button several times to do this.
4.
Press the Capacity button repeatedly to select the quantity. You can prepare
300 ml, 600 ml, 900 ml or 1,200 ml. The standard capacity is 600 ml. The
appliance processes large quantities in two cycles. However, all ingredients
must be poured into the mixing container at the beginning.
5.
Fill the water tank with filtered water.
6.
Pour all ingredients into the mixing container.
7.
Press the Start/Cancel button to start the programme.
8.
Press the Start/Cancel button again during the first minute to stop the
programme.
9.
The machine pours your drink into the glass container. Warning! The drink and
the glass container are very hot. Hold the glass by the handle only. After the
mixing process is completed, the appliance automatically switches to standby
mode. Now you can remove the milk container. The system automatically
enters the self-cleaning function and the self-cleaning function light comes on.
Empty the residual water tank after cleaning.
Timer / delay function
You can set the machine to prepare the drink at a later time.
1.
To do this, select the programme and the capacity
2.
Press the Timer button. By pressing the button several times, you can
increase the preset time in 30-minute increments, from 30 minutes to a
maximum of 24 hours. The preset time is 8 hours. The programme is then
finished after 8 hours.
3.
Select the programme. For safety reasons, the Soaked Soy, Juice, Milkshake
and Soup programmes are not included.
4.
Add the ingredients and press Start/Cancel .
5.
You can stop the programme and the delay time by pressing the Start/Cancel
button again during the first minute. Now you can make a new selection. After
pressing and holding the Preset button for 5 seconds, the time on the display
will increase and you can release the button when the desired time is reached.
Note: For your health and safety - if the room temperature is higher than 30°C,
do not set the timer to over 12 hours to avoid germ formation.
EN
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

10036344

Table of Contents