How To Hitch; How To Unhitch - Progress FASTWAY e2 92-00-0600 Owner's Manual

Figure 28
Figure 29
Figure 30
Figure 31
Figure 32
Figure 33
Figure 34
Figure 35
Figure 36

How to Hitch

1. With the Fastway hitch head installed, position the hitch ball
directly under the trailer coupler. (Figure 28)
2. Lower the trailer coupler until it is resting on the hitch ball. If the
trailer coupler won't sit properly, adjust the position of your tow
vehicle. (Figure 29)
3. Lock the coupler and insert the safety pin into the coupler latch.
4. Insert the spring arms into the sockets of the hitch head and ensure
that the keeper tab is secure. (Figure 30)
5. Raise the trailer jack until you can slide the spring arms onto the
L-brackets; if needed, use the Snap-up lever. (Figure 31)
6. Insert the Snap L-pins.
7. With both arms secured, lower the jack, then retract it completely.
(Figure 32)
8. Attach the safety chains and breakaway cable.
9. Insert the 7-pin plug. Make sure the plug is clean and free of
debris.
10. Remove your wheel chocks.
11. You are ready to go!

How to Unhitch

1. Properly chock your trailer.
2. Remove the 7-pin plug.
3. Remove the breakaway cable and safety chains.
4. Extend your trailer jack to lift the weight off the spring arms.
(Figure 33)
5. With the tension off the spring arms, remove the Snap L-pins and
slide the spring arms off the L-bracket. (Figure 34)
6. Remove the spring arms from the hitch head.
7. Remove the safety pin and unlock the coupler.
8. Raise the trailer coupler above the hitch ball. (Figure 35)
9. Pull your tow vehicle away slowly, lock your trailer coupler and
you are done. (Figure 36)