Table of Contents
Advertisement
Weight Distribution Setup Table
A Uncoupled from trailer
B Trailer coupled and on hitch ball
without weight distribution
C Fully hitched up with weight
distribution engaged
Calculated weight distribution:
100*(B-C)/(B-A)
Target Between 50-100%
A – Measure from the ground to the bottom of the tow vehicle driver side front wheel well, and
record the distance on line A of the weight distribution calculation table. (Figure 19)
B – Lower the trailer onto the hitch ball and lock the coupler. The full weight of the tongue
should be resting on the hitch. Measure from the ground to the bottom of the tow vehicle
driver side front wheel well. Record this distance on line B of the weight distribution
calculation table. (Figure 20)
C – With the trailer still coupled, use the tongue jack to lift both vehicles until the spring arms
can swing onto the L-brackets. (Figure 21) If needed, use the Snap-up lever to lift the spring
arms onto the L-brackets. (Figure 22) Insert the L-pins and secure them in place. (Figure 23)
Figure 22
Front Fender Height
Figure 23
Example
30"
31"
30 ¼"
75%
Figure 19
Figure 20
Figure 21
Advertisement
Table of Contents
