Page 1
CE Certified by: CERTOTTICS Scarl, Zona Industriale Villanova, 32013 Longarone (BL), Italy Notified Body Number: 0530 ’ WNER ANUAL EL, & FS ODELS...
Page 2
Store in a cool, dry place with no chemical fumes. The PROTO¤ Switch“ goggle system is intended to function with genuine PROTO¤ components in place — lens, goggle, goggle fram Immediately replace any lens that has taken a direct hit from ten feet mask, ear pieces and strap.
Page 3
Do not apply WARNING: ll paintball markers must be anti-fog treatments to any PROTO® Switch™ Goggle lens. chronographed. Do not play where paintball No treatment can prevent fogging under all conditions. velocities exceed 300 feet per second Fogging may occur.
CONTENTS What’s In the Box THIS BOX CONTAINS: ¥ One PROTO Switch“ Goggle System ¥ Owner s Manual Safety Information ¥ Goggle Bag Table of Contents What’s in the Box Getting Started Safety Check Fitting Cleaning 11-12 Storage 1 Visor...
Paintball is an adventure sport. Even when paintball is played as intended you can get hurt. No goggle system can prevent serious injury in all situations. The PROTO¤ Switch“ Goggle system is intended for use by paintball WARNING: The PROTO® Switch™ Goggle players participating in a supervised game of paintball with competent System suffers wear and stress even in normal use.
6 Make sure that the strap is securely attached to the frame (right and left). The PROTO¤ Switch“ Goggle System is not intended for use 7 Make sure the sliding adjustment clips on the strap are with eyeglasses.
Cleaning Continued Cleaning Reminders WARNING: Clean only with plain water. Chemical cleaners (Windex, 409, Simple ¥ Don’t use cleaning solutions other than clear water. Green, etc.) contain alcohol and detergents Windex, 409, or other household cleaners which can weaken the lens and goggle. may damage the lens.
• Do not store your goggle in the trunk of your car. WARNING: Use only your hands when • Do not store your goggle in direct sunlight or near heaters, changing PROTO® lenses. Use of tools is likely stoves or other heat sources. to scratch or damage the lens.
Removing Lens Continued Installing the Lens Tip: PROTO¤ replacement lenses come with a protective film on the inside Remove the Lens from Goggle Frame thermal lens. Leave the protective film on during installation. Remove protective film before use. 1 With both Switch™ lock tabs fully removed, place finger between frame and hard goggle at top center, and pivot frame forward at nose.
Removing the Mask from Hard Goggle ttaching the Visor 1 Moisten the ends of the visor posts. To remove the mask from the goggle frame: 2 Push the left visor post into the round hole on the left side of the mask. 1 Hold the hard goggle in one hand.
Once you have heard that click, your Proto Chin strap is now ® ready for use.
Page 12
This warranty gives you specific legal rights, and you also have other rights which vary from state to state. ® If you have any questions about your PROTO product, please call DYE Precision, Inc. at ( 858) 536-5183 or visit www.protopaintball.com...
Need help?
Do you have a question about the SWITCH EL and is the answer not in the manual?
Questions and answers