Table of Contents
Advertisement
17 (violet)
19 (white;
red
mark)
20 (transparent)
* see also Faults section
The voltage at this pin is a signal
proportional to the instantaneous output.
Voltage Monitor
0-10V corresponds to 0-V
Current capability 1,5mA; R
This pin is pulled to ground when some
failure occurs.
voltage output will be also disabled.
Fault Indicator *
Failures:
This pin is pulled to the ground, when the
HV ON Indicator
module provides power to a load.
MAX
out
In this case the high
•
output short-circuit
•
overvoltage
•
output open-circuit
= 1kOhm
7
Advertisement
Table of Contents
