Table of Contents
Advertisement
ANTI-TIP BR ACKE T INS TALL ATION
KIT INCLUDES
• (1) One anti-tip bracket
• (4) Four 3 ⁄16" masonry screws
wall/floor. It is recommended to secure the bracket
• (8) Eight #12-2" wood screws
to as many floor joists and wall studs as possible.
• (12) Twelve 1/4" washers
TOOLS REQUIRED
• Tape measure
bracket to the wall/floor. Adjust the rear rollers to
just above their lowest position and move the unit to
• Marking utensil
its final position. Raise the rear rollers a minimum
• 1/8" drill bit
of 1/8" to engage the bracket.
• 7/16" socket
• Phillips bit driver
• Drill or ratchet
FIGURE 1.1 - ANTI-TIP BRACKET
36RBF UNIT TOP VIEW
TR-30REF-R-SG-A
= Center Line
–-– = Bracket Location
N O T E : D I M E N S I O N S M AY VA R Y B Y ±
9 9/32"
236mm
C L
TEC_TM_151 | REV. A | EN
987036
I N S T A L L A T I O N
5.19.17 AL
/
"
1
8
24 31/32"
634mm
FLUSH INSTALL
N O T E: D IMENSI O NS M AY VA RY BY ± 1 / 8 " (3.175 m m)
07/28/2021
WARNING –
appliance instability, install the anti-
tip bracket in accordance with the
instructions below.
BEFORE YOU BEGIN
Consult a flooring expert to confirm that the flooring
where the unit will be installed is rated for at least 150
pounds per square foot.
1. Measure and mark the depth of the bracket's
placement in the installation location.
• Flush installation: 24-31/32" (634 mm)
• Proud installation: 22-31/32" (584 mm)
2. Place and center the bracket at the measured
depth.
3. With the bracket as a guide, drill pilot holes into the
wall and/or floor.
NOTE: FOR INCREASED STABILITY, SECURE THE
BRACKET TO AS MANY JOISTS AND/OR STUDS AS
POSSIBLE.
4. With the provided hardware, secure the anti-tip
bracket.
5. Adjust the rear leveling rollers 1/4 turn clockwise.
6. Slide the unit into place and hook the anti-tip
bracket into the castor assembly slots.
T R- 3 6 R B F I N S TA L L GU I D E
To avoid a hazard from
Page 17 of 48
Advertisement
Table of Contents
