Advertisement
URINAL CONTROL SYSTEMS
AquaMate
Installation & Setup
Instructions
Please check your box has the following contents
1 x AquaMate inc standard surface mount box.
1 x 15mm 6v Solenoid Valve.
1 x 1m pre-wired plug and flex
1 x Lithium CR-P2 Battery.
You will require the following:
0.5mm Twin Core Cable
Cable Clips / Trunking / Conduit
Fixing Screws
A selection of hand tools.
Recommended:
Isolation valve— available from Aqualogic
AQUAM.160514
Advertisement
Table of Contents
Related Manuals for AquaLogic AquaMate
Summary of Contents for AquaLogic AquaMate
- Page 1 AquaMate Installation & Setup Instructions Please check your box has the following contents 1 x AquaMate inc standard surface mount box. 1 x 15mm 6v Solenoid Valve. 1 x 1m pre-wired plug and flex 1 x Lithium CR-P2 Battery. You will require the following: 0.5mm Twin Core Cable...
- Page 2 Set at 12 Hour, the urinal will flush every 12 Hours (2 times per 24 hour period) Reset. A reset button is located within the AquaMate to aid with maintenance and pro- gramming. Memory will be cleared and ready for reprogramming.
- Page 3 Press the brown reset button, the unit enters start up mode and gives 2 green LED flashes and 1 red. The AquaMate is now ready to program. NB: If the valve remains open, you may need to reverse blue /brown cable connections to control unit.
- Page 4 Table 1 For Technical help or servicing call 0844 324 0844...
Need help?
Do you have a question about the AquaMate and is the answer not in the manual?
Questions and answers