Engine Rpm Numerical Display; Safety Switch Status Lights - Kubota Z751KWi Operator's Manual

LCD MONITOR
1. Find the service reset box between the seat and the
right-hand fender. It is empty.
(1) Service reset box
2. Get a spare fuse (1 A or larger) from the fuse group
2 of the fuse box (See Replacing the fuses on page
77.) and install it in the service reset box.
The warning lamp will start blinking.
3. After 15 seconds of blinking, the display will show
.
Remove the fuse and put it back where it came
from. The warning lamp will turn "OFF" and the
code will not show anymore.
If error code is displayed, consult your local
"ErrXX"
KUBOTA Dealer to diagnose the problem. (See
Error code mode on page 32.)

4. Engine RPM numerical display

Under normal usage, this display shows the engine
rpm. You can use this gauge to precisely choose the
engine rpm you want to use for operation, and to
engage and disengage the PTO clutch.
If the engine has some trouble, this display will show
the engine error code so you or the dealer can
diagnose the problem.
For example, if the crankshaft position sensor loses
synchronization while the engine is running at
3600 rpm, this display
and
diagnose the engine problem quickly.
If error code is displayed, consult your local
"PXXXX"
KUBOTA Dealer to diagnose the problem.
Z751KWi,Z781KWi,Z781KWTi
will change between
. This allows the dealer to
(1) RPM
(2) Engine error code

5. Safety switch status lights

When you turn the key to the "ON" position, these lights
will turn green only if the switches are in the correct
position for cranking. If they are all green, you can
crank the engine.
If more than one light is not green, start at the top and
correct each switch as you work your way down to the
bottom.
(1) Safety switch status lights
(2) PTO clutch indicator
(3) Parking brake indicator
(4) LH control lever indicator
(5) RH control lever indicator
(6) OPC indicator
OPERATING THE ENGINE
(A) The display change
33