Controller Instructions; Programming Menus - AirClean systems POWDERSAFE 760C Operator's Manual

The AirSafe
™
breakthrough was designed to give the user a variety of options with the ease of fi ngertip
control. The controller board consist of 13 keys, each with a specifi c function:
MODE
����
SELECT
������
SET
���
* All other settings are factory preset and should not be changed.
ALARM Allows deactivation of the audible alarm but keeps the visible
POWER
MAIN MENU -
NOTE: Activating the Lab Event Timer (by menu or Quick Key) will automatically switch
the main menu to display the timer countdown. To switch the display back to the Airfl ow
Monitor, just toggle with the "Select" up arrow key.
10

CONTROLLER INSTRUCTIONS

PROGRAMMING KEYS
Automatic Safety Controller is the fi rst of its kind on the market. This
Allows the operator to move between
different program screens.
Allows movement within each program
screen. The user modifi able
portions of the screen will blink.
Allows operator to adjust the following
user defi nable settings:
• Face velocity
• Lab event timer
alarm armed.
Turns on/off power to the controller and its keys. This DOES NOT
cut off power to the entire enclosure. (The main power switch is located above
the power inlet on the back, right-hand side of the enclosure.)

PROGRAMMING MENUS

Displays the time and date when the main power is on and the controller
power is off. When controller power is activated the screen will display one
of the following and may be changed by pressing the "Select" down arrow key:
• Airfl ow Monitor (Measured in Linear Feet per Minute)
• Lab Event Timer (Preset at 20 minutes)
• Current HEPA fi lter reading (measured in back pressure - BP)
• Current GAS DET reading (If a bonded carbon fi lter is installed)
• Time/Date
• Gas detection