Zenitel SDS-1 Configuration Manual

Step 1: Set a Static IP Address on Your Windows 10 Computer
To access the web interface, your computer must be in the same subnet range as the station. There is a video about this on
the config file download site you were just
1. Click Start, and type Control in the search field, then select Control Panel.
2. Click on Network and Internet.
3. Click on Network and Sharing Center.
4. On the left pane, click the Change adapter settings link.
5. Right-click on your computer's Ethernet network adapter and select Properties.
6. Select the Internet Protocol Version 4 (TCP/IPv4) option.
7. Click the Properties button.
8. Select the Use the following IP address option.
9. Set the IP address (e.g., 169.254.1.90).
10. Set the Subnet mask. (e.g., 255.255.0.0).
11. Click OK.
12. Click Close again to close the network adapter properties.
Step 2: Connect the PC, POE Switch, TCIS-2, and Phone
1. Plug the PC and the Turbine TCIS-2 into the Ethernet POE switch. DO NOT plug in the phone yet. Make sure to turn
off WiFi on your laptop if you can't access the TCIS-2 in the steps below.
2. Allow for about 60 seconds for the Turbine to boot up. The light on the Red call button will be flashing yellow. Now
plug in the phone.
Step 3: SDS-1 Phone Configuration
Network settings
1. Press the round Menu button.
SDS-1 Phone Configuration Guide
on.
Page 1 v1.0