Advertisement
Depending on your roller shutter control board, you may need a short pulse or a long pulse
to operate your roller shutter. You can select the pulse setting by using Dipswitch 2 on the
board - refer to picture on Page 3
Dipswitch 2 On = 30 second pulse
Dipswitch 2 Off - 1 second pulse
Short Pulse Relay (1 sec) - (Dipswitch 2 Off)
Using your mobile phone or landline, dial the simcard number within the unit. You will hear
two ring tones. The unit will then answer the call. Once the call is open you can use the
keypad on your phone to operate the device.
Press key 1 - Relay 1 will pulse for 1 second
Press key 2 - Relay 2 will pulse for 1 second
Pressing key 3 will cancel the command and stop the shutter.
We recommend connecting relay 1 to OPEN/UP and relay 2 to CLOSE/DOWN on your
roller shutter control board.
When you press 1 you will hear a fast dialling tone.
When you press 2 you will hear a slower dialling tone.
If you need the shutter to stop, press 1 or 2 will will stop the movement (dependent on your
roller shutter control board)
Please view the diagram on page 6 for wiring information.
Long Pulse Relay (30 secs) - Deadmans Button (Dipswitch 2 On)
This function is used for roller shutter control boards whereby you need to manually hold
the button to open or close the roller shutter. Pressing the button will hold the relay on for
30 seconds. To cancel the command and stop the opening/closing operation you will need
to press 3 key on your phone.
Pressing key 1 will cause relay 1 to pulse to open for 30 seconds
Pressing key 2 will cause relay 2 to pulse to close for 30 seconds
Pressing key 3 will cancel the command and stop the shutter.
To perform a quick factory reset which will delete ALL of your stored numbers please send
the text command
www.gsm-activate.co.uk
How to Use the Roller Shutter Opener
Factory Reset
Page 5
- 01273462380 - sales@gsm-activate.co.uk
Advertisement
