Operating Tips - Bosch GDR18V-1860C Operating/Safety Instructions Manual

2610067262 GDR GDS GDX18V-1860C 07-21.qxp_GDR GDX 7/16/21 7:30 PM Page 18
Built-in work light
Your tool is equipped with an LED light
(8) for better visibility when using the
tool.
After the trigger (4) is activated, the LED
will then stay on for 10 seconds. The
length of time for afterglow can be
changed in 'Bosch ToolBox' app setting
(if connected).

Operating tips

You will extend the life of your bits and
do neater work if you always put the bit
in contact with the work before pulling
the trigger. During the oper a tion, hold
the tool firmly and exert light, steady
pressure. Too much pressure at low
speed will stall the tool. Too little
pressure will keep the bit from cutting
and cause excess friction by sliding over
the surface. This can be damaging to
both tool and bit.
Driving with variable speed
The technique is to start slowly,
increasing the speed as the screw runs
down. Set the screw snug ly by slowing
to a stop. Prior to driving screws, pilot
and clearance holes should be drilled.
Always hold the tool straight on the bolt
to be tightened.
The best method to determine the right
impacting/tightening duration is by
means of a trial. For small screws, the
right impacting/tightening duration can
be reached in less than 0.5 Sec.
Therefore, work with low RPM and
switch the tool off immediately when the
screw is tight and the impacting sound
can be heard.
For screwing larger, longer wood screws
into hard material, pre-drilling is the best
method.
Tightening Torque
The tightening torque depends on the
duration of the impacting/tightening
action. The largest tightening torque is
achieved after approx. 6 to 10 Sec.
impacting / tightening action.
The torque build-up depends on the
following factors:
Operating Instructions
•
•
•
•
This leads to the following application
cases:
Hard joining application: The joining of
metal to metal with a disk washer. The
maximum torque is reached after a
relative short impacting/tightening
action.
Medium joining application: The joining
of metal to metal when using spring ring
washer, disk spring washer, stud bolts
or bolts/nuts with conical seats.
Soft joining application: The joining of
e.g. metal to wood or insulation material.
For middle or soft joining cases, the
maximum tightening torque is less than
for hard cases. Therefore, a longer
impacting/tightening action is necessary
to arrive at the maximum tightening
torque.
Selecting the working mode
The power tool has two preset working
modes: A and B (20). You can also
program working modes for different
applications and adjust existing modes
via the Bosch Toolbox under A and B.
To switch between the working modes A
and B (20), press the Mode button (7).
By Default Mode A is designed for Self-
Drilling Screws. Auto Slow Down is
activated in both the forward and
reverse directions.
By Default Mode B is designed for Wood
Screws. In the forward direction Auto
Shut-off is activated. In the reverse
direction Auto Shut Off functions as
Auto-Bolt Release for the default Mode
B.
Note: Only one Setting or Mode can be
active on the tool at a time. 1, 2, 3, A, or
B.
Fastening with screws
This procedure shown in (Fig. 11) will
enable you to fasten ma terials together
18
Hardness of the bolts/nuts.
Type of washer (disk washer, spring
washer, seal).
Hardness of the material to be
joined.
Lubricating effect at the surfaces of
the junction.