Charging The Battery; Mounting The Aera In The Aircraft - Garmin aera 190-01117-02 Pilot's Manual

charGiNG the Battery

NOTE: While in Charge Mode, the unit draws a current from the aircraft. To
avoid discharging the aircraft's battery, disconnect the external power cable
from the unit when not in use for several days.
Charge the aera for at least 4 hours before using on battery power. Charge the
battery by connecting the vehicle or aviation power cable, the USB cable, an AC adapter
(optional accessory), or use a battery charger (optional accessory).
Plug the unit into a 12-Volt or 24-Volt connector to charge. The unit can be used
while it is charging. Charge the unit within the following temperature range
104°F (0° to 40°C).
Charging the unit's battery using the aircraft's power outlet:
1) Mount the aera in the aircraft (refer to Appendix D 'Installation and
Interfacing'), and connect the power cable to the aircraft power outlet
(cigarette lighter receptacle).
2) Route the power cable so that it does not interfere with aircraft operation.
The unit begins charging as soon as external power is applied.
USING CHARGE mOdE
Applying external power to the aera automatically turns on the unit for full operation.
If the battery is present and needs to be charged, the external power source charges
the battery while the unit is in use.
If you do not want to use the unit, but you would like to charge the battery, you can
put the unit into Charge Mode. Connect the unit to an external power supply. Press
and hold the POWER Button. Instead of completely turning off, the unit now goes
into Charge Mode.
The unit will run cooler and may allow more current to be available while in Charge
Mode, when XM is unplugged, the backlight is turned down, etc.

MOuNtiNG the aera iN the aircraFt

Refer to Appendix D 'Installation & Interfacing' for information on mounting the
aera in the aircraft.
190-01117-02 Rev. A Garmin aera 500 Series Pilot's Guide
Overview
: 32° to
3