Advertisement
2
Removing the Guards
Machines Equipped with MyRide
Only
No Parts Required
Procedure
Note:
Retain all removed parts for later installation.
1.
Remove the bolts securing the guards on the
sides of the frame.
2.
Remove the guards on both sides of the frame
(Figure
1).
Figure 1
3
Installing the Weights
®
Parts needed for this procedure:
4
Bolt (3/8 x 1 inch)
6
Locknut (3/8 inch)
1
Left weight-mounting bracket
1
Right weight-mounting bracket
2
Washer
2
Bolt (5/8 x 2-3/4 inches)
8
Suitcase weight
Procedure
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
g308507
1.
Install the weight-mounting brackets to the under
side of the frame using 2 bolts (3/8 x 1 inch),
and 2 locknuts (3/8 inch) as shown in
2.
Install suitcase weights to the weight mounting
brackets using 2 bolts (5/8 x 2-3/4 inches), 2
washers, and 2 locknuts (3/8 inch) as follows:
•
If your machine has a 42-inch stamped deck,
install 8 suitcase weights.
•
If your machine has any other cutting deck,
install 6 suitcase weights
3.
Once you have installed all the weights and
brackets, ensure that all the fasteners are tight.
Tighten as necessary.
Important:
bagger attachment, remember to remove the
front weights to return the proper stability
to the machine.
2
(Figure
Whenever you remove the
Figure
2.
3).
Advertisement
