Table of Contents
Advertisement
Available languages
Available languages
en Cleaning and servicing
Display
1
Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement: The appliance is switched off.
1.
Press and hold
for a few seconds.
a The first basic setting is shown on the display.
2.
Use the rotary selector to change the basic setting.
3.
Press
.
a The next basic setting is shown on the display.
4.
Use
to select all of the required basic settings
and change the values.
16 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
16.1 Tips on caring for your appliance
Follow the tips on appliance care to make sure your
appliance functions properly at all times.
Measure
Always keep the appli-
ance clean and remove
dirt immediately. Always
clean the cooking com-
partment after use.
Remove limescale,
grease, starch and albu-
min (e.g. egg white)
stains immediately.
Use the glass tray for
baking very moist cakes.
Use suitable cookware for
roasting, e.g. a roasting
dish.
16.2 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶
Do not use steam- or high-pressure cleaners to
clean the appliance.
26
Basic setting
Water hardness
Factory setting
Demo mode
Advantage
Prevents dirt from accu-
mulating and burning on.
Prevents corrosion.
Keeps the cooking com-
partment cleaner.
Keeps the cooking com-
partment cleaner.
Selection
= softened
= soft
= moderate
= hard
1
= very hard
1
= off
= on
1
= off
= on
5.
To save the changes, press and hold
seconds.
Note: The changes to the basic settings will be re-
tained even after a power cut.
15.3 Discarding changes to the basic
settings
▶
Turn the function selector.
a All changes are discarded and not saved.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
▶
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
content.
▶
Do not use hard scouring pads or cleaning
sponges.
▶
Do not use any special cleaners for cleaning the ap-
pliance while it is hot.
▶
Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
New sponge cloths contain residues from production.
▶
Wash new sponge cloths thoroughly before use.
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
16.3 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
▶
Caution should be exercised here in order to avoid
touching heating elements.
▶
Young children under 8 years of age must be kept
away from the appliance.
Description
Set the water hardness
→ Page 13.
Reset the changed settings
to the factory settings.
Switch demo mode on or
off.
Note: Demo mode is only
visible in the first 5 minutes
after connecting the appli-
ance to the mains.
for a few
Advertisement
Table of Contents
